KINGSTON MEMORIA 8GB DDR4 2666 MHZ CL19

DESCRIPTION SPECIFICATIONS *Power will vary depending on the SDRAM used. KVR26N19S8/8 8GB 1Rx8 1G x 64-Bit PC4-2666 CL19 288-Pin DIMM Continued >> FEATURES This document describes ValueRAMs KVR26N19S8/8 is a 1G x 64-bit (8GB) DDR4-2666 CL19 SDRAM (Synchronous DRAM), 1Rx8, memory module, based on eight 1G x 8-bit FBGA components. The SPD is programmed to JEDEC standard latency DDR4-2666 timing of 19-19-19 at 1.2V. Each 288-pin DIMM uses gold contact fingers. The electrical and mechanical specifications are as follows: CL(IDD) Row Cycle Time (tRCmin) Refresh to Active/Refresh Command Time (tRFCmin) Row Active Time (tRASmin) Maximum Operating Power UL Rating Operating Temperature Storage Temperature 19 cycles 45.75ns(min.) 350ns(min.) 32ns(min.) TBD W* 94 V - 0 0o C to +85o C -55o C to +100o C Power Supply: VDD=1.2V Typical VDDQ = 1.2V Typical VPP - 2.5V Typical VDDSPD=2.2V to 3.6V Nominal and dynamic on-die termination (ODT) for data, strobe, and mask signals Low-power auto self refresh (LPASR) Data bus inversion (DBI) for data bus On-die VREFDQ generation and calibration Single-rank On-board I2 serial presence-detect (SPD) EEPROM 16 internal banks; 4 groups of 4 banks each Fixed burst chop (BC) of 4 and burst length (BL) of 8 via the mode register set (MRS) Selectable BC4 or BL8 on-the-fly (OTF) Fly-by topology Terminated control command and address bus PCB: Height 1.23 (31.25mm) RoHS Compliant and Halogen-Free https://www.kingston.com/dataSheets/KVR26N19S8_8.pdf